Steps of the processing plant

• Use a vibration feeder with a 70mm grizzly bar at first. The -70mm materials will be washed using a trommel scrubber.
• The scrubber has a one-layer screen size of 30mm; the screen material can be manganese or PU. The more than 30mm materials will be sent away by a belt conveyor. The less than 30mm materials will go to a high-frequency vibration screen with a 2mm screen.
• The 2-30mm materials will be sent to the hammer crusher by belt conveyor to crush to be smaller, like less than 2mm. Then use a slurry pump to send the slurry back to the high-frequency vibration screen to screen again.
• The less than 2mm materials will go to several sets of jig separators to do the first-time separation. The concentrate will be separated and gathered under the screen in the jig. The screen size in the jig can be 2mm.
• The concentrate from the jig under the screen will be sent to the shaking table. After separating them by the shaking table, you can gather them and send them to the drying ground.
• The materials above the jig screen are tailings and some gold nuggets. They’ll go to the sluice box. The carpet will catch the gold nuggets and some fine-sized columbite.
• Then the tailings from the sluice box will go to a spiral sand washer for dewatering so that you can process the tailings more easily.
• Suppose there are too many magnetic ores(like magnetite, hematite, etc.) inside your concentrate ores after you dry them. In that case, you can send them to the 3pcs disc dry magnetic separator to remove the magnetic materials and get the final concentrated columbite ores.

The capacity for this processing plant can be customized as per request such as 30tph, 40tph,100tph, etc.